Gateway 6400 Instrukcja Użytkownika Pobierz pdf (Strona 43)

34 Replacing and Adding System Components

7 Place the old drive in an antistatic bag or container, then place the new

hard drive on a static-free surface with the top up and the connectors

facing you.

8 Install two small, plastic drive mounting rails (L rail on the left and R rail

on the right) to the new hard drive. Make sure the front rail extensions

are towards the connector end of the device. Align the wire retention clips

to the mounting holes in the drive and press the rails to the sides of the

drive.

9 Set the drive jumpers to the appropriate settings (refer to your drive

documentation for jumper settings).

10 Align the rails with an open bay in the bottom drive cage, and slide the

drive into the cage until the locking tabs snap into place. Be sure that

the data and power connectors on the drive face out.

11 Connect the power and data cables to the drive.

12 Close the case by following the instructions on page 20.

13 Reconnect peripherals, the modem cord, and the power cord, then turn

on the system.

Adding a hard drive

The system comes equipped with a drive cage that will accept additional hard

drives. You may have to purchase an additional data cable with three

connectors and of sufficient length to connect the existing hard drive and

the new drive to the appropriate drive controller connector (IDE or SCSI) on

the system board.

Rrail

Lrail

05032.book Page 34 Monday, July 10, 2000 11:43 AM

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 147 148

Brak uwag

Gateway 6400 Instrukcja Użytkownika Strona 43