Gateway 8450R Instrukcja Użytkownika Pobierz pdf

Documentation Update...

Replacing the Power Supply

This update replaces the procedure provided in the Gateway

8450R System Manual.

The redundant 350-W power supply provides all system

power. If one of the components of the power distribution

hardware fails, you must replace the entire power supply.

1 Turn off the server and disconnect the power cord and

all peripherals.

2 Remove the bezel and both top panels following the

instructions in the system manual.

3 Remove the four screws that secure the upper drive bay

bracket in place, then slide the bracket forward before

lifting it from the chassis.

4 Disconnect the cables from the bottom front side of the

hot-plug fan tray. Note the location and orientation of

each cable so you can connect them correctly to the new

board.

Upper drive

bay bracket

8506762.fm Page 1 Thursday, August 10, 2000 1:32 PM

1 2 3 4

Podsumowanie treści

Strona 1 - Replacing the Power Supply

Documentation Update...Replacing the Power SupplyThis update replaces the procedure provided in the Gateway 8450R System Manual.The redundant 350-W po

Strona 2 - Fan tray

5 Remove the two screws that secure the fan tray, then lift the tray out of the chassis and place it on a static-free surface.6 Disconnect all cables

Strona 3 - Captive thumbscrew

7 Loosen the captive thumbscrew at the bottom of the power supply front, then slide the power supply forward until it stops.8 Tilt the power supply fo

Strona 4

11 Tighten the captive thumbscrew at the bottom of the power supply to secure it in place.12 Place the fan tray in the chassis and secure it with the

Komentarze do niniejszej Instrukcji

Brak uwag

Gateway 8450R Instrukcja Użytkownika

Przeglądaj online lub pobierz Instrukcja Użytkownika dla Podwozie sprzętu sieciowego Gateway 8450R. Gateway 8450R User's Manual Instrukcja obsługi

Podsumowanie treści

Komentarze do niniejszej Instrukcji